DOMINO - IP66 Series

DISTRIBUTION ASSEMBLIES

	DOMINO System: Modular enclosures for consumer units and distribution units General catalogue: sez. 3.1: Distribution assemblies
	Products: fam. 670: Distribution assemblies portable fam. 671: Distribution assemblies surface mounting fam. 654: Accessories for distribution assemblies

GENERAL DESCRIPTION
......................................................................................................................................................

DOMINO Series distribution assemblies are modular, compact, robust, versatile and feature a high protection degree. They satisfy a wide range ofrequirements in normal and special environments. The cabinets are made of impact-resistant self-extinguishing thermoplastic material with outstanding dielectric, thermal and mechanical properties ensuring a long life and safe operation. With their modern design and pleasing appearance they are suitable for installation even in special environments, such as hospitals, banks, supermarkets, etc

USE
......................................................................................................................................................

Their typical uses are in industrial, commercial and agricultural facilities.They are also good for workshops, laboratories, ports for leisure craft, recreational facilities, camping grounds, etc

VERSIONS
......................................................................................................................................................

They come in two size (WxHxD):
DOMINO 400 - 320x400x140mm
DOMINO 550 - 320x550x140mm

Installation:
- surface mounting
- panel mounting
- portable with cable and plug

Capacity:
DOMINO 400 distribution assemblies:
3 IEC309 or Eureka Series 16A/32A socket outlets, or
2 OMNIA Series 16A/32A interlocked-switch sockets, or
3 European 10A/16A domestic type socket outlets or
any combination of the above.
DOMINO 550 distribution assemblies:
6 IEC309 Sor Eureka Series 16A/32A socket outlets, or
4 OMNIA Series 16A/32A interlocked-switch sockets, or
6 European 10A/16A domestic type socket outlets or
any combination of the above.

The wide range of possible combinations of the above socket outlets gives an outstanding versatility to DOMINO distribution assemblies.

TECHNICAL CHARACTERISTICS
......................................................................................................................................................

• Double insulation
• IP44 and IP66 protection degree
• Compliance with :
  EN60439-1, CEI 17-13/1 (all versions)
  EN60439-4, CEI 17-13/4 (portable versions)

CONSRUCTION CHARACTERISTICS
......................................................................................................................................................

The protective gear (MCBs and RCDs) is housed inside the cabinet in a separate compartment, fitted with a DIN rail and cover with a clear tinted window which locks with a triangular key. DOMINO distrubution assemblies can contain up to 16 DIN modules of modular gear.

DOMINO 550 distribution assemblies may be provided with a 150 VA or 300 VA isolating transformer with a 220-250/24 V ratio for the supply of safety extra low voltage (SELV).

General protection of the distribution assemblies may be provided by MCBs and RCDs in the portable version and by MCBs alone in the surface or flush mounting versions.

Additional characteristics of Domino distribution assemblies are described in detail in section 2.1 "Enclosures for electrical equipment: DOMINO System", p. 81 of this catalogue.

Distribution assembly intended for the main power supply cable protection in a building site.
In particular protects the part of the cable that runs from the electrical supply to the building site's distribution assembly.
It should be installed at the beginningof the line, just downstream of the power supply outlet.

1 - Fornitura di energia
2 - Quadro Domino 12 DIN
(fam. 671)
3 - Linea di alimentazione > 3 metri
4 - Quadro Masterbox